SURGE ARRESTER SPECIFICATIONS SAMPLE 72.5 kV


Surge Arresters w Corona Rings
Below is a sample of a specification of Surge Arrester. Some of the basic parameter are covered. You may use it as a guide in selection and specifying Surge Arresters for your specific needs. Take note that not everything is covered on the specs. Use it only as a guide.

SURGE  ARRESTERS
                  
Brand:   Brand of Choice
Class :   Station Class
Installation:   Outdoor Type
Voltage Rating (kV rms) : 60
MCOV Rating (kV rms) : 48
Front-of-Wave Protective Level (kV crest):  175
Maximum Discharge Voltage (kV crest) : - 1.5 KA  125
Switching Surge Protective Level (kV crest)  @ 500 A :  117
Creepage Distance :  68 in.
Insulation Withstand Voltage :
    - 1.2/50 Impulse (kV Crest) 358
    - 60Hz dry 60 sec (kV rms) 200
Rated Arrester Discharge Energy   >9 kJ/KV of MCOV
Conductive Material :  Metal Oxide
Housing : Silicon Rubber/Polymer
Line Teminal Connection: NEMA Four-hole Pad
Ground Terminal Connection:  NEMA Four-hole Pad
Mounting Arrangement :  Mounting Base Located on Bottom (Standard Mounting)

Comments

Post a Comment

Popular posts from this blog

TRANSMISSION LINE CONDUCTOR ICE LOADING BASICS AND TUTORIALS

Image
When a conductor is covered with ice and/or is exposed to wind, the effective conductor weight per unit length increases. During occasions of heavy ice and/or wind load, the conductor catenary tension increases dramatically along with the loads on angle and deadend structures. Both the conductor and its supports can fail unless these high-tension conditions are considered in the line design. Certain utilities in very heavy ice areas use glaze ice thickness of as much as 2 in (50 mm) to calculate iced conductor weight. Similarly, utilities in regions where hurricane winds occur may use wind loads as high as 34 lb/ft2 (1620 Pa). As the NESC indicates, the degree of ice and wind loads varies by region. Some areas may have heavy icing, whereas some areas may have extremely high winds. The loads must be accounted for in the line design process to prevent a detrimental effect on the line. Some of the effects of both the individual and combined co...
Read more

LONGEST POWER TRANSMISSION LINE IN THE WORLD

Image
Yup, you read it right. This is about the World's Longest Overhead Transmission Line as of today. It is around 1700 km in length, transmitting power of 560 MW. Interestingly enough it its transmission voltage is 500 kV dc, mainly due its relatively long distance.
Read more

INSULATION COORDINATION IEC STANDARD APPROACH BASICS AND TUTORIALS

Image
The detailed procedure for insulation co-ordination set out in IEC 60071-1 (European standard EN60071-1 is identical) consists of the selection of a set of standard withstand voltages which characterize the insulation of the equipment of the system. This set of withstands correspond to each of the different stresses to which the system may be subject: • Continuous power frequency voltage (the highest voltage of the system for the life of the system). • Slow-front overvoltage (a standard switching impulse). • Fast-front overvoltage (a standard lightning impulse). • Very-fast-front overvoltage (depends on the characteristics of the connected apparatus). • Longitudinal overvoltage (a voltage between terminals combining a power frequency voltage at one end with a switching (or lightning) impulse at the other). These voltages and overvoltages need to be determined in amplitude, shape and duration by system study. For each class of overvo...
Read more
free counters